Initial installation of vRealize Automation 7.x fails with a "Validation failed" status for the "Retry All IaaS" operation
search cancel

Initial installation of vRealize Automation 7.x fails with a "Validation failed" status for the "Retry All IaaS" operation

book

Article ID: 319618

calendar_today

Updated On:

Products

VMware Aria Suite

Issue/Introduction

Symptoms:
  • Initial installation fails with a "Validation failed" status for the "Retry All IaaS" operation
  • The "Retry All IaaS" function results in an message in the Description field that is similar to: "An item with the same key has already been added."


Environment

VMware vRealize Automation 7.6.x
VMware vRealize Automation 7.x

Resolution

This issue is resolved in VMware vRealize Automation 7.6, available at VMware Downloads.

Workaround:
To workaround this issue, follow the steps given below:
  1. SSH into the vRealize Automation appliance in which is the primary postgres node.
    1. su postgres
    2. psql
    3. \c vcac
  2. Run the following SQL update statement on the embedded vPostgres database:
UPDATE cluster_commands set output='' where type like '%install%';
  1. Re-initiate the "Retry All IaaS" operation again.
Note: If the SQL statement is executed before the installation is started, "Retry All IaaS" does not fail.


Powered by Wolken Software