Configuration

1. Ensure your Broadcom NetXtreme II Ethernet device is capable, enabled, and supported for FCoE Offload. Contact your supplier to ensure that your device is capable and enabled for FCoE offload. Reference the ESXi hardware compatibility list (HCL) to ensure that your device is supported as an FCoE CNA.
2. Install the latest Broadcom NetXtreme II device drivers
3. Activate FCoE on each port through either the vSphere UI or through the ESXi host CLI.

Using vSphere UI

1. Through the vSphere Client on the host to be configured, click the Configuration tab.
2. Under Hardware, select Storage Adapters.
3. Click Add.
4. Select Add Software FCoE Adapter.
   
   Note: The Broadcom FCoE solution is full offload, but is referred to as software FCoE through the vSphere interfaces.
    
5. Select your Physical Network Adapter from the list, and click OK.

Using ESXi CLI

1. Determine which interfaces are FCoE capable by running this command:
   
   # esxcli fcoe nic list
    
2. For a capable interface, you see output similar to:
   
   vmnic4
   User Priority: 3
   Source MAC: FF:FF:FF:FF:FF:FF
   Active: false
   Priority Settable: false
   Source MAC Settable: false
   VLAN Range Settable: false
    
3. Activate FCoE by running this command:
   
   # esxcli fcoe nic discover –n vmnicX
    
4. Verify that the interface is activated by one of these steps:
    
   1. # esxcli fcoe adapter list
      
      For each FCoE adapter, you see an output similar to:
      
      vmhba35
      Source MAC: xx:xx:xx:xx:xx:xx
      FCF MAC: xx:xx:xx:xx:xx:xy
      VNPort MAC: xx:xx:xx:xx:xx:xz
      Physical NIC: vmnic8
      User Priority: 3
      VLAN id: 2008
       
   2. # esxcfg-scsidevs –a
      
      For HBA devices, you see an output similar to:
      
      vmhba35 bnx2fc link-up fcoe.1000bc305b01823c:2000bc305b01823c () Software FCoE

1. If your interface is not listed under esx fcoe nic list, contact your supplier's technical support channels to verify that your devices is FCoE capable.
2. Verify that the ESX CLI FCoE adapter list reflects the correct FCF MAC and VLAN ID. If it is not correct, ensure that the VLAN is enabled for FCoE and relevant interfaces are properly configured per switch documentation.
3. If Disks/LUNs are not visible through the activated FCoE interfaces:
   1. Verify that the target interfaces are properly zoned with initiator interfaces in the FC/FCoE fabric(s).
   2. Verify that the storage array selective LUN presentations are properly configured to present the correct LUNs to the initiator WWN
4. If NMP is not properly discovering all available paths to the storage:
   1. Verify that you have properly configured SATP rules for your storage array. Refer to the storage array vendor for proper array configuration and rule selection.

Additional Information

• 日本語: Broadcom NetXtreme II FCoE オフロード対応イーサネット デバイスに対する FCoE 構成および基本トラブルシューティング (2097850)
• 简体中文: Broadcom NetXtreme II FCoE 具有负载分流功能的以太网设备的 FCoE 配置和基本故障排除 (2102090)